Open-Sided Half-Slope Tent for Factory Loading and Storage in Indahpura Industrial Estate

Half-Slope Tent for Factory Loading and Storage

This Half-Slope Tent installation provides overhead cover beside a factory building. The supplied photos show an open-sided bay with pallets and goods stored beneath the canopy. The photographed installation is in Johor, Malaysia. The arrangement may suit a factory staging, loading or storage area, subject to the site's layout, conditions and access needs.

Suitable applications

• Covered staging or storage beside a factory building
• A sheltered area near a loading or dispatch zone
• A covered work area where the factory layout and vehicle access allow

Visible design details

• Single-slope roof form shown in the supplied photos
• Open-sided bay in the photographed installation
• Supporting frame visible; its material, member sizes, anchoring and structural capacity have not been specified

Site planning and specifications

Product dimensions, cover and frame specifications, anchoring, drainage, structural ratings, installation scope and warranty terms were not provided. Confirm these details with SUNTECH before agreeing on a specification or quotation.

For a site assessment, provide the opening width, required projection and clear height, with units. Include wide photos or a drawing showing the frontage, sides, roof edge, ground, drains, doors, utilities and possible obstructions. State the largest vehicle or equipment that must pass through, its height and turning space, plus any operating or safety constraints.

Frequently asked questions

What factory applications is this Half-Slope Tent suitable for?

The Half-Slope Tent shown can be considered for overhead cover beside a factory building, including a staging, loading or storage bay. The photos show pallets and goods stored in an open-sided area. Share the intended activity and access requirements so SUNTECH can assess whether the arrangement suits your site.

Can the Half-Slope Tent be sized for our factory site?

Required dimensions and available design options should be confirmed for the site; the supplied information does not specify customisation options. Send the opening width, required projection and clear height, along with site photos or a drawing. SUNTECH can review the requirements and confirm suitable options before a specification is agreed.

What measurements and photos should we send for a quotation?

Send the bay width, projection and required clear height with measurement units, plus wide photos of the frontage, sides, roof edge, supports and ground. Include a drawing if available, the project location and intended use. Point out drains, doors, utilities, nearby structures and possible access or fixing constraints.

How should forklift and truck access be planned?

Plan around the tallest vehicle or equipment, its load, turning path and loading position. State the required clear height and width and show the approach route in your photos or drawing. SUNTECH should review these access needs against the proposed support positions and site layout before confirming a design.

What site conditions should be checked before installation?

Check the building edge, ground, drainage, overhead obstructions and potential fixing locations before installation. The photos alone do not establish site suitability or engineering requirements. Provide site details and ask SUNTECH to confirm what design and installation checks are required.

What affects the quotation and how are specifications confirmed?

A quotation depends on confirmed dimensions, cover and frame specifications, site conditions, access, installation scope and operating or safety requirements. SUNTECH should confirm these details, warranty terms and completion timing; they were not supplied with the photos. Include the required date and quantity, if applicable, in your project brief.

Request a project assessment

Planning a covered area for your factory? Send SUNTECH your company name, contact person, project location, intended use, required quantity, approximate dimensions and units, clear height, vehicle access needs, site photos or drawings, preferred fixed or retractable arrangement (if relevant), target completion date, and any installation, safety or engineering requirements. The team can review the brief and confirm what is needed for a quotation.

Contact SUNTECH through the contact page or call +6016-791 6849 / +6010-543 8832.